Cabletron Systems SmartSwitch Router Spécifications télécharger pdf (Page 299)

100

101

Chapter 31: rip Commands

SSR Command Line Interface Reference Manual 31 - 5

rip set broadcast-state

Purpose

Determines if RIP packets will be broadcast regardless of the number of interfaces

present. This is useful when propagating static routes or routes learned from another

protocol into RIP. In some cases, the use of broadcast when only one network interface

is present can cause data packets to traverse a single network twice.

Format

rip set broadcast-state always | choose | never

Mode

Configure

Description

The

rip set broadcast-state

command specifies whether the SSR broadcasts

RIP packets regardless of the number of interfaces present.

Parameters

always | choose | never

Specifies whether the SSR broadcasts RIP packets

regardless of the number of interfaces present.

Specify one of the following:

•

always

– Always sends RIP broadcasts regard-

less of the number of interfaces present.

•

choose

– Sends RIP broadcasts only if more

than one interface is configured on the SSR.

This is the default state.

•

never

– Never sends RIP broadcasts on

attached interfaces.

Restrictions

None.

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 361 362

Commentaires sur ces manuels

Pas de commentaire

Cabletron Systems SmartSwitch Router Spécifications Page 299

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cabletron Systems SmartSwitch Router