Cabletron Systems SmartSwitch Router Spécifications télécharger pdf (Page 260)

Chapter 28: port Commands

28 - 6 SSR Command Line Interface Reference Manual

Restrictions

Note the following restrictions:

• Unless you are mirroring the traffic form the Control Module, you must specify

either an input port or an output slot.

• You cannot specify the

any

keyword with both the

traffic-from

and

traffic-to

options at the same time.

• None of the ports on the slot containing the protocol analyzer port can send or

receive traffic while port mirroring is taking place. When a port is selected to receive

mirrored traffic, none of the other ports on the line card can be used for normal traf-

fic. For this reason, the protocol analyzer port cannot be on the same slot (line card)

as the mirrored port(s).

• Do not configure an interface on the protocol analyzer port.

Examples

Here are some examples of port mirroring commands.

ssr(config)# port mirroring to et.1.1 traffic-from et.3.1 traffic-to any

Copies traffic coming from port et.3.1 and going to any slot. The copied traffic is

sent to port et.1.1, to which the protocol analyzer is attached.

ssr(config)# port mirroring to et.1.1 traffic-from any traffic-to 4

Copies traffic coming from any port and going to slot 4. The copied traffic is sent

to port et.1.1, to which the protocol analyzer is attached.

ssr(config)# port mirroring to et.1.1 cpu-port-traffic

Captures all traffic going to and from the Control Module. The copied traffic is

sent to port et.1.1, to which the protocol analyzer is attached.

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 361 362

Pas de commentaire

Cabletron Systems SmartSwitch Router Spécifications Page 260