Cabletron Systems SSIM-R8-02 Spécifications télécharger pdf (Page 386)

Configuring PPP Interfaces

366 Enterasys Xpedition User Reference Manual

After you configure one or more service profiles for your PPP interface(s), you can then

apply a service profile to active PPP WAN ports, specifying their behavior when handling

PPP traffic. The following command line displays all of the possible attributes used to

define a PPP service profile:

Note: If it is necessary to specify a value for Bridging, IP, and/or IPX, you must specify

all three of these values at the same time. You cannot specify just one or two of

them in the command line without the other(s).

Applying a Service Profile to an Active PPP Port

Once you have created one or more PPP service profiles, you can specify their use on one

or more active PPP ports on the XP. The following command line displays a simplified

example of this process:

Configuring Multilink PPP Bundles

The Multilink PPP (MLP) standard defines a method for grouping multiple physical PPP

links into a logical pipe, called an “MLP bundle”. Large packets are fragmented and

transmitted over each physical link in an MLP bundle. At the destination, MLP

reassembles the packets and places them in their correct sequence.

The following table describes the commands for configuring MLP:

Define a PPP

service profile.

ppp define service <service name> [bridging enable|disable ip enable|disable

ipx enable|disable] [high-priority-queue-depth

<number>] [lcp-echo

on|off] [lcp-magic on|off] [low-priority-queue-depth

<number>] [max-

configure

<number>] [max-failure <number>] [max-terminate

<number>] [med-priority-queue-depth <number>] [red on|off] [red-

maxTh-high-prio-traffic

<number>] [red-maxTh-low-prio-traffic

<number>] [red-maxTh-med-prio-traffic <number>] [red-minTh-

high-prio-traffic

<number>] [red-minTh-low-prio-traffic <number>]

[red-minTh-med-prio-traffic

<number>] [retry-interval <number>]

[rmon on|off]

Apply a service profile to

an active WAN port.

ppp apply service <service name> ports <port list>

Add PPP port(s) to an MLP bundle.

ppp add-to-mlp <mlp > port <port list>

Create MLP bundle(s).

ppp create-mlp <mlp list> slot <number>

Set MLP encapsulation format.

ppp set mlp-encaps-format ports <port list> [format

short-format]

1 2 ... 381 382 383 384 385 386 387 388 389 390 391 392 393 394

Commentaires sur ces manuels

Pas de commentaire

Cabletron Systems SSIM-R8-02 Spécifications Page 386

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cabletron Systems SSIM-R8-02