Cabletron Systems SSIM-R8-02 Spécifications télécharger pdf (Page 294)

Configuring IPX Routing

274 Enterasys Xpedition User Reference Manual

Enabling SAP

IPX SAP is enabled by default on the XP. You must first create an IPX interface or assign

an IPX interface to a VLAN before SAP will start learning services.

Configuring Static Routes

In a Novell NetWare network, the XP uses RIP to determine the best paths for routing IPX.

However, you can add static RIP routes to RIP routing table to explicitly specify a route.

To add a static RIP route, enter the following command in Configure mode:

Configuring Static SAP Table Entries

Servers in an IPX network use SAP to advertise services via broadcast packets. Services

from servers are stored in the Server Information Table. If you want to have a service

explicitly advertised with different hops, you will need to configure a static entry.

To add an entry into the Server Information Table, enter the following command in

Configure mode:

Controlling Access to IPX Networks

To control access to IPX networks, you create access control lists and then apply them with

filters to individual interfaces. The XP supports the following IPX access lists that you can

use to filter various kinds of traffic:

• IPX access control list: Restrict traffic based on the source address, destination address,

source socket, destination socket, source network mask or destination network mask.

• SAP access control list: Restricts advertisements or learning of SAP services. These lists

are used for SAP filters. They can also be used for Get Nearest Server (GNS) replies.

• RIP access control list: Restricts advertisements or learning of networks.

Add a static RIP route.

ipx add route <networkaddr>

Add a SAP table entry. ipx add sap <service type> <SrvcName> <node>

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 393 394

Pas de commentaire

Cabletron Systems SSIM-R8-02 Spécifications Page 294