Cabletron Systems SSIM-R8-02 Spécifications Page 345

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 394
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 344
Enterasys Xpedition User Reference Manual 325
Limiting Traffic Rate
To define a port rate limit policy, enter one of the following commands in Configure
mode:
Note that for output port policies, the only action that you can specify if traffic exceeds the
specified rate is to drop packets.
If you configure output port policies, all types of outgoing IP traffic will be rate limited,
including control traffic. If you do not want control traffic to be subject to rate limiting,
enter the following command in Configure mode:
Because you specify a slot number in the above command, output port rate limiting
policies on any port on the specified slot will not be applied to control traffic.
Aggregate Rate Limiting
Use an aggregate rate limiting policy if an aggregation of flows needs to be limited to a
particular rate. For example, you can use aggregate rate limiting to rate limit traffic to or
from a particular subnet.
Note: You cannot apply an aggregate rate limiting policy to an interface that spans ports
on more than one line card. For example, you cannot apply an aggregate rate
limiting policy to the interface ip2, if ip2 interfaces to a VLAN that consists of
ports et.1.(1-4) and et.2.(1-4).
To configure aggregate rate limiting policies, you must first enable aggregate rate limiting
mode on the XP (see Rate Limiting Modes on page 323).
Define a port rate limit policy to
limit incoming traffic on a port.
rate-limit <name> port-level input rate <rate-limit> port
<port list> {drop-packets|no-action|lower-priority|lower-
priority-except-control|tos-precedence-rewrite
<val1> |tos-
precedence-rewrite-lower-priority
<val2>}
Define a port rate limit policy to
limit outgoing traffic on a port.
rate-limit <name> port-level output port <port list> rate
<rate-limit> drop-packets
Specify that control traffic is not
subject to output port rate
limiting.
rate-limit <name> port-level slot <slot-number> ignore-
control-priority
Vue de la page 344
1 2 ... 340 341 342 343 344 345 346 347 348 349 350 ... 393 394

Commentaires sur ces manuels

Pas de commentaire