Cabletron Systems SSIM-R8-02 Spécifications télécharger pdf (Page 148)

100

101

Monitoring RIP

128 Enterasys Xpedition User Reference Manual

Configuring RIP Route Preference

You can set the preference of routes learned from RIP.

To configure RIP route preference, enter the following command in Configure mode.

Configuring RIP Route Default-Metric

You can define the metric used when advertising routes via RIP that were learned from

other protocols. The default value for this parameter is 16 (unreachable). To export routes

from other protocols into RIP, you must explicitly specify a value for the default-metric

parameter. The metric specified by the default-metric parameter may be overridden by a

metric specified in the export command.

To configure default-metric, enter the following command in Configure mode.

For

<num>, you must specify a number between 1 and 16.

Monitoring RIP

The rip trace command can be used to trace all rip request and response packets.

Enable acceptance of RIP routes

that have a metric of zero.

rip set check-zero-metric disable|enable

Enable poison reverse, as

specified by RFC 1058.

rip set poison-reverse disable|enable

Specify the maximum number

of RIP routes maintained in the

routing information base (RIB).

The default is 4.

rip set max-routes <number>

Disable multipath route

calculation for RIP routes.

Rip set multipath off

Set the preference of routes learned from RIP. rip set preference <num>

Define the metric used when advertising routes

via RIP that were learned from other protocols.

rip set default-metric <num>

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 393 394

Commentaires sur ces manuels

Pas de commentaire

Cabletron Systems SSIM-R8-02 Spécifications Page 148

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cabletron Systems SSIM-R8-02