Cabletron-systems ELS10-26TX Manuel d'utilisateur télécharger pdf (Page 11)

– 5 –

Installing a Fast Ethernet Port Interface

Module (FEPIM)

The ELS10-26 provides a slot for a Cabletron FEPIM (Fast

Ethernet Port Interface Module). The ELS10-26 is shipped without

an FEPIM. To install an FEPIM, follow the procedure below:

1. Remove power cord.

2. Remove the cover of the ELS10-26.

3. Remove the two screws securing the plate on the side of the

FEPIM slot.

4. Install the FEPIM as shown in the illustration. Ensure that the

rear module connector is seated ﬁrmly before tightening the

three mounting screws.

5. Replace the plate and two screws on the side of the FEPIM

slot.

6. Replace the cover of the ELS10-26.

Only qualiﬁed personnel should perform installation

procedures.

1742-39

FE-100TX

100

Standoff

Standoffs

Module

Motherboard

Connector

Module

Connector

Faceplate

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Cabletron-systems ELS10-26TX Manuel d'utilisateur Page 11