Cabletron Systems RoamAbout Guide d'installation télécharger pdf (Page 22)

Remote Power Adapter Installation

2-4 Cabling and Wiring

Remote Power Adapter Installation Procedure

Use the following procedure to install the remote power adapter.

Step Action

1 If available, use a cable tester to check the cable wiring to the Access Point.

Check continuity and pairing.

2 Select a mounting location:

• Close to the Ethernet wiring panel or Ethernet port.

• Within six feet of an AC power outlet (if remote power is used).

Secure the remote power

adapter.

If necessary, use the two wall

anchors provided in your

installation kit.

Insert the Ethernet cable

connector into the NETWORK

jack.

Insert the Access Point cable

connector into the ACCESS

POINT jack.

Before you connect to the remote power adapter, verify that the wired

network connector is inserted into the NETWORK jack, and the

Access Point is connector is inserted into the ACCESS POINT jack.

6 Proceed to Chapter 3, Installing the Access Point.

PWR

Network

Access

Point

Mounting

Hole (2)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Pas de commentaire

Cabletron Systems RoamAbout Guide d'installation Page 22