Cabletron Systems RoamAbout Guide de l'utilisateur télécharger pdf (Page 57)

Configuring Your Access Point 4-13

Access Point Installation Menu

RoamAbout Access Point INSTALLATION MENU

[2] Reset with Current Settings

This option reboots the AP but leaves the module’s configured NVRAM parameters at

their current settings.

NOTE

Allow approximately 1 minute for the module to reset and complete its self-test.

The following example shows the dialog associated with this option.

NOTE

If you change any wireless configuration parameter (Wireless Network Name,

Channel, Station Name, etc.), you must select this option to reset the AP.

==========================================================

RESET WITH CURRENT SETTINGS

This selection will reset your system with the current

configuration settings.

==========================================================

Press Y to confirm [N] :

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Pas de commentaire

Cabletron Systems RoamAbout Guide de l'utilisateur Page 57