Cabletron Systems SmartSwitch Router Spécifications télécharger pdf (Page 37)

SmartSwitch Router 2100 Getting Started Guide 21

Chapter 2: Hardware Installation

2. Make sure the TXD signals from the SSR 2100 emerge as RXD signals on the

management console and the TXD signals from the management console emerge as

RXD signals on the SSR 2100.

3. After ensuring that the pin assignments on both ends of the connection are correct,

plug the appropriate end of the connection into the SSR 2100’s RJ-45 10/100Base-TX

port.

4. Plug the other end of the connection into the management console’s port.

5. When you are ready to configure the SSR 2100 using CoreWatch or SNMP, use

procedures in Chapter 4, “Installing and Starting Cabletron CoreWatch” on page 43 to

start an SNMP or CoreWatch management session.

Attaching Cables to Gigabit Ports

The 1000Base-SX ports on the Gigabit Modules support multimode fiber (MMF). The

Gigabit Modules use SC-style Media Interface Connectors (MICs) to attach to MMF

cables.

To attach the segment cables to the Gigabit Modules, obtain an MMF cable with an SC

MIC and plug the MIC into the port connector. When you plug the other end of the cable

into another device, make sure that the cable connected to the transmit port on the SSR

2100 is connected to the receive port on the other device. The receive port on the SSR 2100

should be connected to the transmit port on the other device.

a. The right hand column pin assignments are for the RJ-45 connector on the SSR 2100. Thus, pin 1 (TXD

or “transmit data”) must emerge on the management console’s end of the connection as RXD (“receive

data”) and so on.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

Pas de commentaire

Cabletron Systems SmartSwitch Router Spécifications Page 37