Cabletron Systems 6H123-50 Spécifications télécharger pdf (Page 61)

SPECTRUM Enterprise Manager 61 SmartSwitch6000

Modeling

This section describes how to manually model a 6C105 chassis and a SmartSwitch 6000 module installed in the

chassis and place the resulting device icons in their proper SPECTRUM views.

Introduction

The following topics are covered in this section:

• AutoDiscovery vs. Manual Modeling on

Page 61

• Manual Modeling Overview on Page 62

• Preparation for Modeling on Page 63

• Modeling Using the Chassis IP on Page 63

• Positioning the Chassis Device Icon on Page 66

AutoDiscovery vs. Manual

Modeling

SPECTRUM’s AutoDiscovery is recommended if

you are modeling a network for the first time or

want to discover and model a network segment

after making changes to it.

AutoDiscovery is not recommended for use when

the SmartSwitch 6000 is in Mixed Management

mode, see Management Modes.

Autodiscovery involves manually modeling a seed

router, bridge, or switch (if such a model does

exist) and then running AutoDiscovery one or

more times to complete the network model. You

then refine your autodiscovered network model to

improve management capabilities.

The manual modeling procedures described in

this section should be used when making minor

changes to the network. This includes such

Note:

Refer to Getting Started with

SPECTRUM for Administrators and

How to Manage Your Network with

SPECTRUM for instructions on using

AutoDiscovery and refining your

network model.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 69 70

Pas de commentaire

Cabletron Systems 6H123-50 Spécifications Page 61