Cabletron-systems 9T101-04 Manuel d'utilisateur

MMAC-Plus ™ 9T101-04Four Port Token Ring RouterUser’s Guide

Introduction1-2 Management Information Base (MIB) Support All concentrator modules provide MIB support including the following:• IETF Source Routing

1-3Features Figure 1-1. The 9T101-04 ModuleMMAC PLUS

Introduction1-4 Related Manuals The manuals listed below should be used to supplement the procedures and technical data contained in this manual. MMA

2-1 Chapter 2 Installing the MMAC-Plus Module The MMAC-Plus module may be installed into any of the 14 slots that are available. To install, follow t

Installing the MMAC-Plus Module2-2 Figure 2-1. Installing the MMAC-Plus Module7FLNK8FLNKFLNK10FLNKINS11FLNKINS12RXTXRXTXRXCircuit CardCard GuidesMeta

2-3The Reset Switch The Reset Switch The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2. It serves two

Installing the MMAC-Plus Module2-4 Table 2-1. Terminal Setup RequirementsMenu Function SelectionDisplay Columns 80 ColumnsSetup: Controls Interpret C

2-5Local Management Console An RJ-45 connector provides a CON interface to the management terminal. Figure 2-3 shows the pinouts. Figure 2-3. Console

Installing the MMAC-Plus Module2-6

3-1 Chapter 3 Operation The 9T101-04 Token Ring Router module is a four port router. Four front panel network connections can be made to this module

Operation3-2 Flexible Network Bus (FNB) The FNB consists of two dual FDDI networks, the FNB-1 and FNB-2, providing up to 400 Mbps of data bandwidth.

3-3FNB Interface FNB Interface MMAC-Plus modules are designed with one of two attachment policies. One allows dual attachment of a module to either F

Operation3-4

4-1 Chapter 4 LANVIEW LEDs The front panel LANVIEW LEDs, shown in Figure 4-1, indicate the status of the module and may be used as an aid in troubles

LANVIEW LEDs4-2 The functions of the System Management Bus (SMB) and CPU LEDs are listed in Table 4-1. * At least one Token Ring port in both groups

4-3LANVIEW LEDs The functions of the Token Ring Insertion LEDs are listed in Table 4-4.The function of the Ring Speed LEDs are listed in Table 4-5.Ta

LANVIEW LEDs4-4

5-1 Chapter 5 Specifications Safety This equipment meets the following safety requirements: • UL 1950• CSA C22.2 No. 950 • EN 60950• IEC 950• EMI Requ

Specifications5-2 Physical Dimensions 35.0 D x 44.0 H x 3.0 W centimeters(13.8 D x 17.4 H x 1.2 W inches) Weight Unit: 1.36 kg. (3 lb)Shipping: 1.81

i Notice Notice Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior

ii Notice FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may no

iii Notice DOC Notice This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio

iv Notice

v Contents Chapter 1 Introduction Features...

Contentsvi

1-1 Chapter 1 Introduction The 9T101-04 Token Ring Router module, shown in Figure 1-1, is a four port Token Ring router. Up to four front panel netwo