Cabletron Systems MR-9T Guide d'installation télécharger pdf (Page 15)

Page 3-1

INSTALLATION

CHAPTER 3

INSTALLATION

When you unpack the MR9, verify that you have received the

following:

• One 15 Vdc, 0.9 Amp wall mount transformer with attached

power cord

• Two sets of Velcro



mounts

• Ten 6 inch tie wraps

• Four cable clamps

After you are sure that you have met all requirements listed in

Chapter 2, Specifications and Requirements, complete the

installation instructions provided in this chapter.

3.1 MOUNTING THE MR9

Using the two sets of Velcro mounts included in the accessory

package, you can wall mount the MR9.

1. Separate the two Velcro mounts.

2. Peel off the paper that covers the adhesive backing of one Velcro

mount.

3. Carefully position the Velcro on the back of the MR9. Press

firmly so that the adhesive firmly affixes to the unit.

4. Place the other half of Velcro on the surface where you want to

mount the MR9.

5. Mount the repeater by attaching the Velcro-backed MR9 to the

Velcro mount.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Cabletron Systems MR-9T Guide d'installation Page 15